How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask GM Tech (Cam) Your Own Question
GM Tech (Cam)
GM Tech (Cam), Chevy Technician
Category: Chevy
Satisfied Customers: 29427
Experience:  GM Grand Master Technician 2007. 14 years experience.
10949255
Type Your Chevy Question Here...
GM Tech (Cam) is online now
A new question is answered every 9 seconds

Replace actuator stills blows cold air on passenger side

Customer Question

replace actuator stills blows cold air on passenger side stills blows cold air
Submitted: 1 year ago.
Category: Chevy
Expert:  GM Tech (Cam) replied 1 year ago.

Hi there I am Cam. Can you tell me what base model you have? Truck? Car? Engine size?

Customer: replied 1 year ago.
2002 chevytrailbalzer ltz
Customer: replied 1 year ago.
6.2 2002 chvy ytail blazer
Customer: replied 1 year ago.
I sill just wait for a response from you
Expert:  GM Tech (Cam) replied 1 year ago.

OK, can you tell me what location your actuator was in?

Customer: replied 1 year ago.
on the passenger side below glove compartment
Customer: replied 1 year ago.
beside center console
Expert:  GM Tech (Cam) replied 1 year ago.

Sorry for the delay, I work also on the ambulance and had a call. SO you replaced the proper actuator, so did you do a reset afterwards? Usually all that is required is the system needs to be re-calibrated 3 times to clean the feedback circuit in the actuator off. This is done by removing the battery for 10 seconds. Attach the battery then start the engine for 3 mins. Shut the engine off and then repeat this 2 more times.

Customer: replied 1 year ago.
what do mean by actuator off do mean do this before connect actuator
Expert:  GM Tech (Cam) replied 1 year ago.

No, afterwards.

Customer: replied 1 year ago.
Did not work still doing the same thing
Expert:  GM Tech (Cam) replied 1 year ago.

OK so if you remove the actuator and move the shaft by hand, do you get full proper heat?

Related Chevy Questions