How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Roy Your Own Question
Roy, import/domestic specialest
Category: Chevy
Satisfied Customers: 5303
Experience:  ASE master tech for 40 years
Type Your Chevy Question Here...
Roy is online now
A new question is answered every 9 seconds

92 k1500. New motor. Stage two clutch. New cylinder.

Customer Question

92 k1500. New motor. Stage two clutch. New slave cylinder. Flywheel bearings and pressure plate. I was riding down the road and the pedal basically went limp. Has no pressure at all. I've bled the line but still won't get pressure.
Submitted: 1 year ago.
Category: Chevy
Expert:  Roy replied 1 year ago.

good evening my name is ***** ***** I will assist

you made no mention of the clutch master cylinder. this may be the failure. are there any leaks??


Customer: replied 1 year ago.
There are no leaks. It has recently been changed also.
Expert:  Roy replied 1 year ago.

when you open the bleeder valve is there pressure when the pedal is pushed???


Customer: replied 1 year ago.
Barely any at all. But there's a dust cover on the side of the transmission housing as to where I can see the end of the clutch fork and where the slave cylinder push rod. And I can push on the clutch fork and there is a lot of pressure on it. Just nine to the pedal. Almost as if it didn't
Customer: replied 1 year ago.
Expert:  Roy replied 1 year ago.

ok, it sounds like you need a master cylinder. thats where all the prssure is created