How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete
Pete, Auto Service Technician
Category: Chevy
Satisfied Customers: 24728
Experience:  14 years GM dealer Technician.
14928985
Type Your Chevy Question Here...
Pete is online now
A new question is answered every 9 seconds

Chevrolet suburban: I am having the sameish problem on a cummins

Customer Question

I am having the sameish problem on a cummins swap.
I am using a Chevy sensor, replaced it twice,
Grounded out the garage wire and it pegged all the way up,
It's two wire that are dark green and dark brown,
When wife's or wire are disconected it reads 0, When connected it goes to 100 and stops.
The thermostat is also new
Submitted: 1 year ago.
Category: Chevy
Customer: replied 1 year ago.
There are a couple of other wires not being used at the moment
One blue and one brown
Expert:  Pete replied 1 year ago.
My name is ***** ***** I am a professional here at Just Answer. I noticed that your question was not getting a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.
My info is limited on your model here but I see no one else has responded and thought I would see if I can help here.
Make sure the engine is grounded properly in the vehicle with more then one point on the engine grounded.I have seen gauge issues in the past before due to improper or insufficient grounds on the engine and had to correct this here.
Thanks Pete