How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gary Your Own Question
Gary
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 15925
Experience:  15 years GM master tech
19513769
Type Your Chevy Question Here...
Gary is online now
A new question is answered every 9 seconds

Chevrolet: 2009 chevy cobalt 2.2L Please send instructions

This answer was rated:

2009 chevy cobalt 2.2L

Please send instructions on how to remove and replace the camshaft position actuator solenoid. Thanks

Welcome! My name is XXXXX XXXXX I will do my best to assist you with this problem.Ask me about added features such as phone contact anytime if you wish !

you need to replace the intake or the exhaust cam shaft solenoid ?

 

 

Customer: replied 3 years ago.

The one that is under the valve cover.

Ok Robert here is the procedure

 

Camshaft Position Actuator Solenoid Valve Replacement

Removal Procedure



 

 

 

 

  1. Remove the intake cover.
  2. Disconnect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.



 

 

 

 

  1. Remove the exhaust (1) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
  2. Remove the intake (2) CMP actuator solenoid valve bolt and valve, as required.
  3. Inspect the solenoid valve O-ring seals from damage, replace as necessary.

Installation Procedure



 

 

 

 

  1. Lubricate the solenoid valve O-ring seals with clean engine oil.

 

  1. Install the intake (2) CMP actuator solenoid valve and bolt, as required and tighten the bolt to 10 Nm (89 lb in) .
  2. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required and tighten the bolt to 10 Nm (89 lb in) .



 

 

 

 

  1. Connect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
Customer: replied 3 years ago.

The guy says its the exhaust type camshaft position actuator solenoid. Is there different instructions for this? It looks like its under the valve cover but your instructions do not say anything about that. ???????\

 

 

And why did you send pictures of a rear differential in your response?

 

Are these instructions for the exhaust actuator solenoid?

 

Awaiting your response.

im sorry the pictures times out

remove the valve cover then follow this here

 

Attachment: 2013-11-07_215517_2009_cam.docx

 

 

Customer: replied 3 years ago.

never mind. The exhaust type is right on top of the engine bud

Robert did it come out ok for you ?
Gary and other Chevy Specialists are ready to help you

Related Chevy Questions