How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask JOHN aka Eauto Your Own Question
JOHN aka Eauto
JOHN aka Eauto, The Car Guy
Category: Chevy
Satisfied Customers: 15076
Experience:  ase tech
6149662
Type Your Chevy Question Here...
JOHN aka Eauto is online now
A new question is answered every 9 seconds

Chevrolet Impala LT: In a 2006 chevy Impala, which fuse is

This answer was rated:

In a 2006 chevy Impala, which fuse is actually for the hvac system?? I need to remove it to calibrate a new blend door actuator. There are no fuses actually labeled as for the heating system.
Hi . Thank you for asking your question on JustAnswer.

RE-CALIBRATING ACTUATORS

CALIBRATION PROCEDURE
Use
the following steps to perform the calibration update:


  1. Turn OFF the ignition.
  2. Remove the battery positive voltage circuit fuse of the HVAC Control Module.

  3. Wait 60 seconds .

IMPORTANT: The module memory will not clear if the battery positive
voltage circuit fuse is installed in less than 60 seconds .



  1. Install the fuse.



RE-CALIBRATING ACTUATORS

CALIBRATION PROCEDURE
Use
the following steps to perform the calibration update:


  1. Turn OFF the ignition.
  2. Remove the battery positive voltage circuit fuse of the HVAC Control Module.

  3. Wait 60 seconds .

IMPORTANT: The module memory will not clear if the battery positive
voltage circuit fuse is installed in less than 60 seconds .



  1. Install the fuse.
Thank you again for trusting us with your problem. John aka eauto
graphicgraphicgraphic
JOHN aka Eauto and 2 other Chevy Specialists are ready to help you
graphic
its the display fuse 10 amp labeled hvac in the pic