How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gary Your Own Question
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 15574
Experience:  15 years GM master tech
Type Your Chevy Question Here...
Gary is online now
A new question is answered every 9 seconds

1996 chevy: when changing the fuel filter..diesel..reservoir

Customer Question

when changing the fuel filter on a 1996 chevy k2500 diesel. Where is the reservoir that is referred to on the filters packaging ?
Submitted: 6 years ago.
Category: Chevy
Expert:  Gary replied 6 years ago.
you are changing the fuel filter correct?and the packing says it is located in the reservoir?is this correct?you need to know where the reservoir is?
Customer: replied 6 years ago.
the package instructs you to drain the fuel filter reservoir
Expert:  Gary replied 6 years ago.
this is how you change it.there is no drain to let the fuel out of the reservoir.just follow this and you will be fine

  1. Fuel tank filler cap.
  2. Open air bleed valve on top of the fuel manager/filter to release any pressure in the fuel supply system.
  3. Element nut by turning it in a counterclockwise direction. If unable to turn by hand, a strap wrench may be used to "break loose" the element nut.
  4. Element by lifting it straight up and out of the header assembly. It is not necessary to drain fuel from the header assembly to change the filter element since the fuel will remain in the header assembly's cavity. NOTE : Make sure the mating surface between the element assembly and the header assembly is clean before installation.


  1. New element assembly by aligning the widest key slot located under the element assembly cap with the widest key in the header assembly.
    • Push the element in a downwards direction until the mating surfaces make contact.
  1. Element nut. Tighten
    • Element nut securely by hand.
  1. Bleed air from fuel manager/filter.
  2. Reinstall fuel tank filler cap.

Related Chevy Questions