How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gary Your Own Question
Gary
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 16492
Experience:  15 years GM master tech
19513769
Type Your Chevy Question Here...
Gary is online now
A new question is answered every 9 seconds
Chevy

WHERE IS THE CAMSHAFT SENSOR LOCATED ON A 96 CHEVY 6.5 DIESEL

TRUCK?
Submitted: 6 years ago.
Category: Chevy
Ask Your Own Chevy Question
replied 6 years ago.

the cam sensor is built into the injection pump assembly.if you have the cam or optic code and its running bad or will not run then the injection pump assembly needs to be changed.either with a new.rebuilt or remove and find a shop online that will rebuild this unit for you

graphic

Customer reply replied 6 years ago.

NO CODES FOUND, IT HAS NEW PMD, AND A NEW INJECTION PUMP.

Gary, Chevy Technician replied 6 years ago.
ok..so what is wrong with it?why did the pump get changed?
Customer reply replied 6 years ago.
WE REPLACED THE PMD, AND INJECTION PUMP, AND NOW 2 MONTHS LATER IT STILL WONT START!
Gary, Chevy Technician replied 6 years ago.
ok the cam sensor is in the pump it is not serviced separately..NOW did you bleed the air out and try to start it?does it have fuel going into the pump?
Customer reply replied 6 years ago.
YES I HAVE AN YES IT DOES.
Gary, Chevy Technician replied 6 years ago.
when cranking loosen any fuel line to any fuel injector and see if fuel is getting to the injector its self
Customer reply replied 6 years ago.
WE ARE NOT GETTING ANY FUEL ...ITS NOT SMOKING @ ALL!!
Gary, Chevy Technician replied 6 years ago.
at the FSD connector on the side of the pump with the key on do you have 12 volts at the pink wire?if 12 volts plug it back in and then un plug engine cut off solenoid see if it starts.then reconnect that connector and unplug the optical fuel temp sensor will it start and run with that unplugged?#2 in this picture.if it still will not start reconnect that connector and then disconnect fuel solenoid driver and see what you have for voltage at the light green wire which CRANKING.let me knowgraphic

Related Chevy Questions