How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Z. Your Own Question
Ron Z.
Ron Z., - Chevy Tech -
Category: Chevy
Satisfied Customers: 17954
Experience:  18+yrs experience. State Inspector and Chevy Diagnostics
18617752
Type Your Chevy Question Here...
Ron Z. is online now
A new question is answered every 9 seconds

2005 chevy Monte Carlo LT: you change a speed sensor..disconnect

This answer was rated:

How do you change a speed sensor in a 2005 chevy Monte Carlo LT and do you also need to disconnect the battery?
Removal Procedure
  1. Raise and support the vehicle. Refer to Vehicle Lifting.
  2. Remove the right front tire and wheel.
  3. Disconnect the vehicle speed sensor (VSS) electrical connector.graphic
  4. Remove the VSS bolt (9).

  5. Remove the VSS (10) from the extension case.
  6. Remove the O-ring (11) from the VSS (10).graphic

Installation:

  • Install the O-ring (11) to the VSS (10).
  • Install the VSS (10). Notice: Refer to Fastener Notice in Service Precautions.
  • Install the VSS bolt (9). Tighten the bolt (9) to 12 Nm (106 inch lbs.).
  • Connect the VSS electrical connector.
  • Install the right front tire and wheel.
  • Lower the vehicle
  • Ron Z. and 3 other Chevy Specialists are ready to help you
    Customer: replied 7 years ago.
    Do I have to disconnect the battery?
    No. it is not neccesary to disconnect battery.

    Related Chevy Questions