How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dan Your Own Question
Dan
Dan, Auto Technician
Category: Chevy
Satisfied Customers: 3490
Experience:  GM Mark of Excellence/ Service Guild Participant with 13 years experience, ASE Master Certified
4976144
Type Your Chevy Question Here...
Dan is online now
A new question is answered every 9 seconds

how do you replace the wiper arm on a 2000, chevy s-10 pickup

This answer was rated:

how do you replace the wiper arm on a 2000, chevy s-10 pickup truck

If rocking the arm back and forth with the nut off doesn't release it from the shaft use a battery terminal puller to get under the arm and pop it off.

 

Windshield Wiper Arm Replacement

Removal Procedure


    Object Number: 443596  Size: SH
    Click here for detailed picture of above image.
  1. Mark the wiper park position on the windshield with a suitable non-permanent marker.
  2. Remove the cover from the wiper arm nut.
  3. Remove the wiper arm retaining nut.
    Object Number: 443598  Size: SH
    Click here for detailed picture of above image.
  4. Remove the wiper arm from the wiper transmission drive shaft.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 443598  Size: SH
    Click here for detailed picture of above image.
  1. Install the wiper arm onto the wiper transmission drive shaft.
    1.1. Align the wiper arm with the marks made on the windshield.
    1.2. Push the wiper arm down onto the wiper transmission drive shaft completely.

    Object Number: 443596  Size: SH
    Click here for detailed picture of above image.
  2. Install the retaining nut onto the wiper transmission drive shaft and the wiper arm.

    Tighten
    Tighten the nut to 23 N·m (17 lb ft)

  3. Install the cover on the wiper arm nut.
Dan and other Chevy Specialists are ready to help you