How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Anthony Your Own Question
Anthony
Anthony, Chevy Technician
Category: Chevy
Satisfied Customers: 11750
Experience:  GM Certified
15218643
Type Your Chevy Question Here...
Anthony is online now
A new question is answered every 9 seconds

remove starter on 97 blazer 4wdr 4.3 engine

Resolved Question:

remove starter on 97 blazer 4wdr 4.3 engine
Submitted: 7 years ago.
Category: Chevy
Expert:  Anthony replied 7 years ago.

here it is:

 

Starter Motor Replacement 4.3L 4WD

Removal Procedure

  1. Disconnect the negative battery cable. Refer to General Information.
  2. Disconnect the engine mounts, refer to Engine Mount Replacement (Front, RWD) or Engine Mount Replacement (Front, 4WD) or Engine Mount Replacement (Rear, RWD) or Engine Mount Replacement (Rear 4WD)
  3. Raise the engine.
  4. Support the engine.
  5. Remove the transmission mount. Refer to in Engine Mechanical.
  6. Support the transmission assembly.
    Object Number: 43052  Size: SH
    Click here for detailed picture of above image.
  7. Remove the starter mounting bolts. Rotate the starter for access.
    Object Number: 43021  Size: SH
    Click here for detailed picture of above image.
  8. Remove the wires from the solenoid.
    Object Number: 7307  Size: SH
    Click here for detailed picture of above image.
  9. Remove the starter from the vehicle. Note the location of the shims, if equipped.

Installation Procedure


    Object Number: 43052  Size: SH
    Click here for detailed picture of above image.
  1. Install the starter to the vehicle.
    Object Number: 43021  Size: SH
    Click here for detailed picture of above image.
  2. Connect the wires to the solenoid.
    Object Number: 43052  Size: SH
    Click here for detailed picture of above image.
  3. Install the inboard starter mounting bolt. Do not tighten.
  4. Install the starter shims and the outboard starter mounting bolt. Tighten

    Tighten the starter mounting bolts to 43 N·m (32 lb ft).

  5. Lower the engine assembly onto the mounts.
    • Connect the transmission mount.
    • Connect the engine mounts, refer to Engine Mount Replacement (Front, RWD) or Engine Mount Replacement (Front, 4WD) or Engine Mount Replacement (Rear, RWD) or Engine Mount Replacement (Rear 4WD) refer to in Engine Mechanical.
  6. Connect the negative battery cable.
Anthony and 6 other Chevy Specialists are ready to help you