WHEEL BEARINGIHUB REPLACEMENT - REAR Removal Procedure NOTE: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and or bearing is damaged, replace the complete hub and bearing assembly. 1. Raise and suitably support the vehicle. 2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels. 3. Remove the brake rotor.4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped. 5. Remove the park brake cable from the park brake actuator. 6. Remove the mounting bolts from the rear bearing/hub. 7. Remove the wheel bearing/hub and park brake assembly from the knuckle. 8. Remove the park brake actuator from the rear wheel bearing/hub.
REPLACEMENT. Installation Procedure 1. Install the park brake actuator to the rear wheel bearing/hub. 2. Install the wheel bearing/hub and park brake assembly to the knuckle. 3. Install the wheel bearing/hub-to-knuckle bolts. Tighten Tighten the bolts to 75 N.m (55 ft lbs). 4. Install the park brake cable to the park brake actuator. 5. Install the ABS electrical connector to the wheel speed sensor, if equipped. 6. Install the brake rotor. For 2002, 7. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels 8. Lower the vehicle.