How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dan Your Own Question
Dan, Auto Technician
Category: Chevy
Satisfied Customers: 3490
Experience:  GM Mark of Excellence/ Service Guild Participant with 13 years experience, ASE Master Certified
Type Your Chevy Question Here...
Dan is online now
A new question is answered every 9 seconds

2001 Chevy Tahoe: My keyless entry..tested..batteries..FOB

Customer Question

My keyless entry is not working on my 2001 Chevy Tahoe. The dealer tested the FOBs and they are fine, also just put new batteries in them. Is there a unit in the Tahoe that recieves the signal from the FOB? If so where is it, can it be replaced?
Submitted: 7 years ago.
Category: Chevy
Expert:  Dan replied 7 years ago.
Remote Control Door Lock Transmitter Programming

Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to four transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.

You may program up to 4 transmitters, using either of the two following procedures:

Transmitter Programming Procedure (Method 1 - No Tools Required)

  1. Close all the vehicle doors.
  2. Insert the ignition key into the ignition lock cylinder.
  3. Press and hold the door unlock switch.
  4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
  5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
  6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
  7. Repeat the previous step to program up to four transmitters.
  8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
  9. Operate the transmitter functions in order to verify correct system operation.

Transmitter Programming Procedure (Method 2 - Scan Tool Required)

  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. Use the scan tool in order to access the Body Control Module (BCM) Special Function: Program Key Fobs menu.
  4. Follow the directions on the scan tool in order to program the transmitters.
  5. Operate the transmitter functions in order to verify correct system operation.

Related Chevy Questions