How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Auto Mech / Electronics
Category: Chevy
Satisfied Customers: 20664
Experience:  Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.
1609972
Type Your Chevy Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

How do I program a 2006 Malibu remote control device. The

Customer Question

How do I program a 2006 Malibu remote control device. The VIN number on the remote matches with the car.
Submitted: 8 years ago.
Category: Chevy
Expert:  Don 'Mo Lurch' replied 8 years ago.

You will need Dealer Scan Tool to program Transmitter/s. No Customer programming is possible

 

Here is procedure:

 

TRANSMITTER PROGRAMMING

IMPORTANT: All transmitters that are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode, all previously programmed transmitters will be erased upon receipt of the programming signal from the first transmitter.

Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. Use care to program the transmitters correctly.

The scan tool must stay connected until all of the transmitters are programmed. All doors must be closed to perform this function.

Install CANDI module.
Install a scan tool.
Turn ON the ignition with the engine OFF.
With the scan tool, select Body and Accessories.
Select Keyless Entry.
Select the proper engine size.
Select Module Setup.
Select body control module (BCM).
Select Program Key Fobs.
Follow scan tool on screen instructions.
If you are programming more than one transmitter, repeat the previous step to program up to four transmitters.
Remove the scan tool.
Exit the vehicle. Attempt to lock/unlock the doors to verify the programming.
Operate the transmitter functions in order to verify correct system operation.

Don 'Mo Lurch' and other Chevy Specialists are ready to help you
Customer: replied 8 years ago.
Well, not sure the answer was worth $15 but OK, you owe me one.
Expert:  Don 'Mo Lurch' replied 8 years ago.

Sorry......just the messenger, not the designer................lol
GM does have built in money generators on most vehicles, forcing the customer to buy expensive tools or having the Dealer do it.

 

Again, sorry for the bad news
THANK YOU