How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Carhelp4u Your Own Question
Carhelp4u
Carhelp4u, ASE CERTIFIED TECH
Category: Chevy
Satisfied Customers: 5203
Experience:  ASE CERTIFICATION
3903212
Type Your Chevy Question Here...
Carhelp4u is online now
A new question is answered every 9 seconds

How do i reset the low tire pressure display on my monte carlo 2003

Customer Question

how do i reset the low tire pressure display on my monte carlo 2003
Submitted: 8 years ago.
Category: Chevy
Expert:  Carhelp4u replied 8 years ago.

There are a few different ways to do this on this model. Here is how this can be done. Feel free to contact me with any questions! Good luck!

Important: After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the 3 speed ranges to complete the calibration process. .

Using Exterior lamp switch

  1. Adjust all tire pressures to the recommended kPa/psi.
  2. Turn ON the ignition, with the engine OFF.
  3. Cycle the exterior lamp switch from OFF to parking lamps 3 times within 5 seconds.

 

Using RDS equipped radio (if equipped)

  1. Adjust all tire pressures to the recommended kPa/psi.
  2. Turn the ignition to ACC or ON, with the engine OFF.
  3. Turn the radio OFF.
  4. Press and hold the DISP button until SETTINGS is displayed.
  5. Press the SEEK up or down arrows until TIRE MON is displayed.
  6. Press the PREV or NEXT button to enter the submenu. RESET will be displayed.
  7. Press the DISP button, A chime will sound and DONE will be displayed.
  8. Scroll until EXIT is displayed.
  9. Press the DISP button to exit the TPM reset mode. A chime will sound to verify exit.

 

Using a scan tool

  1. Adjust all tire pressures to the recommended kPa/psi. Install the scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool select Special Functions.
  4. Select TIM Reset.
  5. Press the Reset soft key.

Related Chevy Questions