How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Greg A Your Own Question
Greg A
Greg A, Master Troubleshooter
Category: Chevy
Satisfied Customers: 8105
Experience:  Working with Electronics & Cars for 25+ Years
5229702
Type Your Chevy Question Here...
Greg A is online now
A new question is answered every 9 seconds

Starter location on 2000 chevy blazer?

Resolved Question:

starter location on 2000 chevy blazer?
Submitted: 8 years ago.
Category: Chevy
Expert:  Greg A replied 8 years ago.

HiCustomer Thank you for asking your question on Just Answer.

 

Is this a 2 orXXXXXblazer?

 

Thanks

Customer: replied 8 years ago.
2 wheel
Expert:  Greg A replied 8 years ago.

OK. Let me check and see what I have.

 

Thanks

Customer: replied 8 years ago.
need specific info
Expert:  Greg A replied 8 years ago.

OK. Below is a PDF version of the service manual instructions for replacing the starter. You should be able to click on the link and view the instructions, or right-click and be able to download them to your computer. In either case, you should be able to print the instructions out to carry with you.

 

Replace Starter

 

Here are some more "simplified" instructions (not as much detail). Remember, whenever you see an arrow, it points to the FRONT of the vehicle.

 

Removal & Installation
4.3L Engine
2wd Models

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    • Negative battery cable
    • Wires from the starter solenoid
    • Starter motor mounting bolts
    • Starter motor and if equipped, the shims
    • graphic
    • Starter mounting-4.3L engine

To install:

  1. Install or connect the following:
    • Starter motor into position
    • Starter motor inboard bolt but do not tighten it at this time
    • Starter motor shims, if equipped
    • Outboard starter motor bolt. Tighten the bolts to 32 ft. lbs. (43 Nm).
    • Wires to the solenoid
    • Negative battery cable

 

 

 

I hope this helps. Please let me know how it works out.

 

Take Care, Greg A.

Greg A and other Chevy Specialists are ready to help you
Expert:  Greg A replied 8 years ago.

Here is another diagram that might help.

 

graphic

graphic

 

Take Care, Greg A.