How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Virtual Wrench Your Own Question
Virtual Wrench
Virtual Wrench, Chevy Mechanic
Category: Chevy
Satisfied Customers: 14620
Experience:  35 years Master Mechanic
2617050
Type Your Chevy Question Here...
Virtual Wrench is online now
A new question is answered every 9 seconds
Chevy

95 chevy silverado 1500: keyless entry..troubleshoot..I not obd II

i have a 95 chevy... Show More
i have a 95 chevy silverado 1500 4x4 have the keyless entry remote cant figure out how to program remote and or troubleshoot vehicle is still OBD I not obd II
Submitted: 8 years ago.
Category: Chevy
Show Less
Ask Your Own Chevy Question
replied 8 years ago.

Hello and thanks for asking,

Try this procedure and let me know if you need further assistance.

graphicgraphic

graphic

Customer reply replied 8 years ago.
grounded pin g and nothing happened
Virtual Wrench, Chevy Mechanic replied 8 years ago.

Thanks

Do you only have 1 remote?

Customer reply replied 8 years ago.
yes the original remote i believe
just replaced the batteries
Customer reply replied 8 years ago.
i did not have the key on at all and i grounded pin g but the locks didnt do anything nor did anything else
Virtual Wrench, Chevy Mechanic replied 8 years ago.

Thanks,

Most likely its a fault with the reciever module.

But first you need to check the fuse listed below and the keyless entry relay.

If both check out ok with either a testlight/voltmeter or ohm meter,,then replace the reciever module.

graphicgraphicgraphicgraphicgraphic

Customer reply replied 8 years ago.
ok i checked all fuses and the two relays good but i have another problem that may be linked to this the door locks work manually but the interior lights also only work manually by the dimmer switch and the cargo light only turns on when the dimmer switch is on yet all fuses are good is there something else i can look for also transmitter not located there cannot find this vehicle is a stick and vin number is XXXXX
Virtual Wrench, Chevy Mechanic replied 8 years ago.

Thanks,,

Sorry..the K series (4x4) ,,,,,the module is located behind the left hand sound panel insulator..its more than likely the culprit.

graphic

graphic

Customer reply replied 8 years ago.
ok i have found the module but my bright lights are not working and the bright indicator in the dash does not work i have a feeling that these are related and where can i get a module cheap???