How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask goodwrench9124 Your Own Question
goodwrench9124, ASE Certified Technician
Category: Chevy
Satisfied Customers: 3432
Experience:  Ase Master Certified, GM Master Certified Tech. Awarded GM Top performer, Hybrid certified
Type Your Chevy Question Here...
goodwrench9124 is online now
A new question is answered every 9 seconds

Hello..I have a 2000 chevy s10 pick up 2.2l 4cyl..

Customer Question

Hello..I have a 2000 chevy s10 pick up 2.2l 4cyl.. I would like to get step by step tune up procedures including parts removal and replacement and what parts need to be purchased...Thank you
Submitted: 8 years ago.
Category: Chevy
Expert:  goodwrench9124 replied 8 years ago.

Hello, and welcome to JA!!! tune up parts that will be needed, spark plugs, and you will need plug wires, if your in the 100,000 miles. fuel filter. and a good cleaning of throttle b ody would be a good idea.

Spark Plug Wire Harness Replacement (2.2L)

Removal Procedure

    Object Number: 370382  Size: SH

  1. Disconnect the spark plug wire at each spark plug.
    Twist the boots one-half turn before removing.
    Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.

    Object Number: 175522  Size: SH

  2. Disconnect the spark plug wire from the coil.
    Twist each spark plug boot 1/2 turn.
    Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the coil
  • Remove the spark plug wires. Object Number: 14824  Size: SH

  • Loosen each spark plug one or two turns.

    Most spark plug are best removed from wheel wells.

  • Brush or air blast away any dirt from around the spark plugs.
  • Remove the spark plugs one at a time and place each plug in a tray marked with the corresponding cylinder numbers.
  • In-Line Fuel Filter Replacement

    Removal Procedure

    1. Relieve the fuel pressure.
      Object Number: 63353  Size: SH
    Expert:  goodwrench9124 replied 8 years ago.
    the picture that i have included, is the throttle body, you dont need to remove to clean. just use some good carb cleaner and wipe out with a rag
    Customer: replied 8 years ago.
    Reply to goodwrench9124's Post: Hello..There a quite a few things missing in this answer. It does not say what items need to be removed in order to access the spark plugs and also to replace the wires. If you read the original question it requests all the steps needed step by step and also all psrts locations..thanks..G.E
    Expert:  goodwrench9124 replied 8 years ago.

    hello, there is nothing that needs to be removed to access spark plugs. they are on the drivers side of engine, simply pull off plug wire boots and replace. there is no need to remove anything to replace plug wires either. just pull off wires from coil packs mounted on the right side of egine. and route new wires. i hop this clears up any misunderstanding's


    Related Chevy Questions