How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dan Your Own Question
Dan
Dan, Auto Technician
Category: Chevy
Satisfied Customers: 3490
Experience:  GM Mark of Excellence/ Service Guild Participant with 13 years experience, ASE Master Certified
4976144
Type Your Chevy Question Here...
Dan is online now
A new question is answered every 9 seconds

how do youy change the starter on a 95 chevy s10 pickup

This answer was rated:

No Comment Added
Is it two or four wheel drive? Automatic or manual transmission?
Customer: replied 9 years ago.
automatic eith ltter in reg is W XXXXX
Customer: replied 9 years ago.
XXXXXautomatic
Starter Motor Replacement (4.3L 4WD)

Removal Procedure

  1. Disconnect the negative battery cable. Refer to General Information.
  2. Disconnect the engine mounts, refer to Engine Mount Replacement (Front, RWD) or Engine Mount Replacement (Front, 4WD) or Engine Mount Replacement (Rear, RWD) or Engine Mount Replacement (Rear 4WD)
  3. Raise the engine.
  4. Support the engine.
  5. Remove the transmission mount. Refer to in Engine Mechanical.
  6. Support the transmission assembly.
    Object Number: 43052  Size: SH
    Click here for detailed picture of above imageidth=
  7. Remove the starter mounting bolts.

    Rotate the starter for access.


    Object Number: 43021  Size: SH
    Click here for detailed picture of above imageidth=
  8. Remove the wires from the solenoid.
    Object Number: 7307  Size: SH
    Click here for detailed picture of above imageidth=
  9. Remove the starter from the vehicle.

    Note the location of the shims, if equipped.

Installation Procedure


    Object Number: 43052  Size: SH
    Click here for detailed picture of above imageidth=
  1. Install the starter to the vehicle.
    Object Number: 43021  Size: SH
    Click here for detailed picture of above imageidth=
  2. Connect the wires to the solenoid.
    Object Number: 43052  Size: SH
    Click here for detailed picture of above imageidth=
  3. Install the inboard starter mounting bolt. Do not tighten.
  4. Install the starter shims and the outboard starter mounting bolt.

    Tighten
    Tighten the starter mounting bolts to 43 N·m (32 lb ft).

  5. Lower the engine assembly onto the mounts.
    Connect the transmission mount.
    Connect the engine mounts, refer to Engine Mount Replacement (Front, RWD) or Engine Mount Replacement (Front, 4WD) or Engine Mount Replacement (Rear, RWD) or Engine Mount Replacement (Rear 4WD) refer to in Engine Mechanical.
  6. Connect the negative battery cable.
Dan and 2 other Chevy Specialists are ready to help you