How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask goodwrench9124 Your Own Question
goodwrench9124
goodwrench9124, ASE Certified Technician
Category: Chevy
Satisfied Customers: 3432
Experience:  Ase Master Certified, GM Master Certified Tech. Awarded GM Top performer, Hybrid certified
5720312
Type Your Chevy Question Here...
goodwrench9124 is online now
A new question is answered every 9 seconds

how to set timing on a 93 s10 2.5 litre with a distibutor

Customer Question

No Comment Added
Submitted: 8 years ago.
Category: Chevy
Expert:  goodwrench9124 replied 8 years ago.

Hello, here is the instructions for setting the timing on your truck

Please accept my answer if i was helpfull!!!

graphic

 

graphic

 

PROCEDURE
Set timing under the following conditions:

  • Normal operating temperature.
  • Air cleaner installed.
  • A/C "OFF".
  • Transmission in neutral.
  • Put electronic spark timing (EST) in by pass mode. Connect a jumper lead between terminals A and B of the ALDL connector under the dash.
  • Connect timing light and adjust as necessary by loosening hold down bolt and rotating distributor
  • Tighten hold down and recheck the timing.
  • With ignition "OFF", clear ECM trouble code by disconnecting ECM power source.
  • With engine at operating temperature, drive vehicle at part throttle with moderate acceleration and decelerate to idle condition. This will "teach" the ECM/VCM and return the engine to normal performance.