How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask goodwrench9124 Your Own Question
goodwrench9124
goodwrench9124, ASE Certified Technician
Category: Chevy
Satisfied Customers: 3432
Experience:  Ase Master Certified, GM Master Certified Tech. Awarded GM Top performer, Hybrid certified
5720312
Type Your Chevy Question Here...
goodwrench9124 is online now
A new question is answered every 9 seconds

1995 suburban: blower motor resistor..dashboard to access this

Customer Question

The blower motor resistor on my 1995 suburban is shot. My tech at work said that I shouldnt have to remove dashboard to access this, but online it said that I had to. Which is correct? If the dash needs to come out, how do I get it out?
Submitted: 9 years ago.
Category: Chevy
Expert:  goodwrench9124 replied 9 years ago.

Hello, you dont have to remove dash to replace. you can access thru glove box. here is the instruction.

If this info was helpful please accept my answer!!

graphic

Remove or Disconnect

  1. Negative battery cable.
  2. Instrument panel compartment.
  3. Electrical connectors, as necessary.
  4. Screws (73).
  5. Blower motor resistor (74).

Install or Connect

  1. Blower motor resistor (74). CAUTION: Make sure the resistor coils do not contact each other. Improper operation or system damage may result.
  2. Screws (73). Tighten screws (73) to 1.4 Nm (12 lbs. in.) .
  3. Electrical connectors, as necessary.
  4. Instrument panel compartment.
  5. Negative battery cable.
    • Check circuit operation.

Related Chevy Questions