How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Auto Mech / Electronics
Category: Chevy
Satisfied Customers: 20591
Experience:  Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.
1609972
Type Your Chevy Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

1995 chevy: the steering wheel..airbag..horn

Resolved Question:

how to remove the steering wheel on a 1995 chevy silverado? Or remove the airbag cover to get to the horn connections?
Submitted: 9 years ago.
Category: Chevy
Expert:  Don 'Mo Lurch' replied 9 years ago.

 

graphic

SIR DISABLE:

DRIVER SIDE
Many service procedures require the air bag system to be disabled to prevent accidental deployment. The air bag system can maintain sufficient voltage to cause deployment for up to 2 minutes after the ignition switch is turned off, the battery ground cable is disconnected or the DERM fuse is removed. If the inflator module is disconnected from the deployment loop by the following procedure, service can begin immediately without waiting for the 2 minute time period to elapse.

  1. Turn steering wheel so that vehicle wheels are pointed straight ahead.
  2. Turn ignition switch to Lock position and remove key.
  3. Remove air bag fuse from fuse block.
  4. Remove steering column filler panel.
  5. Remove Connector Position Assurance (CPA) and disconnect yellow two-way connector at base of steering column, Fig. 1.

PASSENGER SIDE

  1. Remove air bag fuse from fuse block.

SIR ENABLE:

Driver Side

  1. Turn ignition switch to LOCK and remove key.
  2. Connect yellow two-way connector and install connector position assurance (CPA).
  3. Install steering column filler panel.
  4. Insert air bag fuse into fuse block.
  5. Turn ignition switch to RUN and verify that the air bag warning lamp flashes seven times then turns off.

Passenger Side

  1. Turn ignition switch to LOCK and remove key.
  2. Insert air bag fuse into fuse block.
  3. Turn ignition switch to RUN and verify that the air bag warning lamp flashes seven times then turns off.

 

Expert:  Don 'Mo Lurch' replied 9 years ago.

BALL TYPE:
graphic

 

LEAF TYPE:

graphic

Don 'Mo Lurch' and 6 other Chevy Specialists are ready to help you
Customer: replied 9 years ago.
How can I remove the steering wheel airbag specifically? I have removed the two screws behind the wheel. Should there be another release point for the bag to come off the wheel?
Expert:  Don 'Mo Lurch' replied 9 years ago.
There are 2 types listed with Instructions for removal. Check to see which type you have, Ball or Leaf & follow instructions