How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George H. Your Own Question
George H.
George H., ASE Certified Technician
Category: Car
Satisfied Customers: 18308
Experience:  ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist
Type Your Car Question Here...
George H. is online now
A new question is answered every 9 seconds

can I resurface rotors that are drilled/slotted?

This answer was rated:

can I resurface rotors that are drilled/slotted? I have my own lathe but I didn't think u could do that please help they cost me a ton of money

Hello I will help you with your question,

Yes they can be cut. The lathe is run very slowly and if it is the type that uses positive rake bits it will cut smoothly. The Ammcos use a negative rake bit that will work but the lathe needs to run very slowly and take a very light cut.

Please let me know how I can help

Thank you

George H. and 5 other Car Specialists are ready to help you

Related Car Questions