How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron
Ron, ASE Certified Technician
Category: Car
Satisfied Customers: 33441
Experience:  ASE Certified Tech
7276279
Type Your Car Question Here...
Ron is online now
A new question is answered every 9 seconds

trooper wagon: how to replace starter motor 2002 v6 troope

This answer was rated:

how to replace starter motor 2002 v6 trooper
Hello and welcome to Justanswer.

Is your Trooper a 4X4 or a 2X2?
Customer: replied 3 years ago.


it is a 4x4

In order to access the starter you will need to remove the exhaust front left pipe . Once you have it our of the way you can access the starter. Be sure to disconnect the negative battery cable before starting the removal . See the factory removal steps Below.

Removal

  1. Battery ground cable.



 

  1. Disconnect Heated O2 Sensor connector (1).
  2. Remove exhaust front left pipe (2).



 

  1. Remove heat protector (3).
  2. Disconnect starter wiring connector from terminals "B" and "S" (4).
  3. Remove starter assembly mounting bolts on inside and outside (5).
  4. Remove starter assembly toward the bottom of engine (6).

Installation

  1. Install starter assembly (6).
  2. Install mounting bolts and tighten bolts to specified torque (5).

Torque: 40 N.m (30 lb ft)

  1. Reconnect the connectors to terminals "B" and "S" and tighten Terminals "B" to specified torque.

Torque: 9 N.m (80 lb in)



 

  1. Install heat protector(3).
  2. Install exhaust front left pipe (2) and tighten bolts and nuts to specified torque.

Stud Nuts

Torque: 67 N.m (49 lb ft)

Nuts (Exhaust front left pipe-Right pipe)

Torque: 57 N.m (42 lb ft)

Nuts (Exhaust front left pipe-Silencer)

Torque: 43 N.m (32 lb ft)



 

  1. Connect Heated O2 Sensor connector (1).
  2. Reconnect the battery ground cable.
Ron and 7 other Car Specialists are ready to help you