How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Marty Your Own Question
Marty
Marty, ASE Certified Technician
Category: Car
Satisfied Customers: 53695
Experience:  ASE & Bosch Certified Master Tech. Over 30 years experience.
13230946
Type Your Car Question Here...
Marty is online now
A new question is answered every 9 seconds

Land Rover P38: I need the wiring diagram for the power supply

This answer was rated:

I need the wiring diagram for the power supply on a 1998 Land Rover p38 Instrument Cluster. I need to know the positive pins and the ground pins so I can power on the unit.
Hi, it looks like pins A4 and A14 and B1 are your power feeds and pins A7 and A17 are your grounds. I've attached the diagram below.

Rover Cluster Schematic

Marty and 3 other Car Specialists are ready to help you
Customer: replied 3 years ago.
Could you help me with a 2003 Nissan Sentra?
Hi, on the Sentra I need to know if it's a 1.8 or 2.5 liter and with or without a tachometer.
Customer: replied 3 years ago.
1.8 without a tachometer.
Ok, on the Sentra pins 23 and 24 are your power feeds and pins 14, 27 and 39 are your grounds. I've attached the schematic below.

Nissan Sentra Cluster

Customer: replied 3 years ago.
Which would be the pins for the illumination?
Pins 33 is power and pin 32 is ground for the illumination.
Marty and 3 other Car Specialists are ready to help you
Customer: replied 3 years ago.

Good day. I have a question about a 2000 BMW information disp[lay system. first i need the wiring diagram so i can power it on and test it, also will this need to be coded in order to work properly? thanks!


 


65.82-8 384 931 is the only # that i see on it

Hi, there is no programming or coding needed for the information display unit. Can you tell me how many pins are in the connector?
Customer: replied 3 years ago.

There are 12.