How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Lurch Your Own Question
Lurch
Lurch, Aftermarket & Factory Electronics
Category: Car
Satisfied Customers: 20710
Experience:  Ford, Chev Cert, Heavy Line Mech, Mobile Electronics.Sales, Installation & Repair for 30 years.
1609972
Type Your Car Question Here...
Lurch is online now
A new question is answered every 9 seconds

How do you remove factory carburetor from 1978 620?

This answer was rated:

How do you remove factory carburetor from 1978 620?

 

 

Nissan Pick Up?

 

 

Customer: replied 4 years ago.


pick up 620... i've bought a replacement carb but can't reach the bolts to remove the old one with any tool

 

 

it is tight & open end wrench is best
I used to have a "bent" one that I made to get to the nuts
I bent the end up to reach in

Here is Nissan / Datsun procedures also

see if this helps

 

>>>> CLICK HERE

 

 

------------------------------------------------------------------------------------------------------------

Please "respond" so I know you have read my answer..............

 

If you need further, please ask "before" you Rate my Answer...............

 

Understand the site gets paid.....I do not recieve anything, until you "Rate my Answer"

 

Please Rate my answer "now" for me to recieve some compensation, as that is how a recieve a small portion of the Deposit................thank you

 

 

 

 

Customer: replied 4 years ago.

how many other parts, if any, do you have to remove so that a "bent" wrench will reach the bolts?


 


how'd you go about bending the wrench?


 

 

 

how many other parts, if any, do you have to remove so that a "bent" wrench will reach the bolts?

 

Please take a look at the .pdf I posted above or below

>>>> CLICK HERE

 

how'd you go about bending the wrench?

 

insert wrench into vise & bend with another or hammer
Use a cheap wrench as they bend easier

 

 

Customer: replied 4 years ago.

 


since these are the original bolts from 1978, what is the best way(s) to prevent stripping?


 


do you know what size the bolts are?

 

 

since these are the original bolts from 1978, what is the best way(s) to prevent stripping?

 

Use a penetrating oil like PB Blaster, wd40, etc.
soak as best you can
use a "tight" fitting wrench

 

do you know what size the bolts are?

 

been awhile, I believe they are 12 or 14mm

 

 

Customer: replied 4 years ago.


thanks so much!! you truly are a life saver.

 

 

THANK YOU........

 

If you need further, please ask "before" you Rate my Answer...............

 

Understand the site gets paid.....I do not recieve anything, until you "Rate my Answer"

 

Please Rate my answer "now" for me to recieve some compensation, as that is how a recieve a small portion of the Deposit................thank you

 

Lurch and 8 other Car Specialists are ready to help you