how did this problem first begin?
what engine do you have?
I pulled up to a red light Thursday afternoon and when I started to proceed through the stop light it went dead and would not crank. Would turn over and would run a few seconds when sprayed with carb cleaner. Was told it was the fuel pump. Fuel pump is working but still won't run.
I have a six cyclinder engine
will it start now with starting fluid?
just for a few seconds and then it will go dead again
and you have fuel pressure at the rail
does this vechile have what they call a fuel modular?
the fuel pump is the fuelmodule
so,,the fuelpump does run,,,correct
oh okay . The fuel pump was taken off. had to lower the gas tank to get to it and it was pumping.
you need to check for an injector pulse
the injectors should pulse when the engine is turning
what is that and how do I do that?
you need a noid light
you unplug an injector wire,,and plug it up to the noid light,,then turn the engine
the light sho
i would think that sense you have fuel pressure
that you dont have an injector pulse
this can be caused by one of two things
1-the crank sensor
2-the ignition module
Lower Right Side of Engine
Under ignition coil pack, at front of engine.
okay. this has helped. Do you have any idea when I could purchase these parts at a reasonable price
it is best to buy new
but,,you can find these at your local salvage tyard
or,,on the net,,try www.ebay.com
okay thanks a million pal
can get good used parts on ebay at a good price sometimes
you are very welcome
Please RATE my answer by clicking the RATINGS button, so I can get credit for my work,,the [BAD SERVICE] and [POOR SERVICE] rating does not give me credit].i don't receive commission if you give a less than 3 star/smiley rating ..I'm not always going to be giving you good news,so please don't let this stand in the way of you accepting my answer.it does not cost you more money.we will still be able to communicate.please understand,i can not see,hear or touch the vehicle and only know what you tell me. Bonuses and positive feedback are appreciated!if you are not satisfied with my answer,please do not leave bad feed back,i will gladly opt out and let another expert handle the question.if i have sent any diagrams,please print them.they will only stay on here for an hour or so...sometimes you may need to right click the image,then save picture as]to save it to your computer so you can open it with your picture program...PLEASE ASK IF YOU NEED MORE HELP