Ask a Car Mechanic and Get Answers to Your Car Questions ASAP
sorry....for the delay
i just got online
the fluiod must be pumped in
there is a plug at the top of the rear trans pan
on the passenger side
you will need to start the rodeo,,let it idle in park
and pump fluid into the fill plug untill it runs out of the fill plug
Changing Transmission Fluid There is no need to change the transmission fluid unless the transmission is used under one or more of the following heavy duty conditions. A. Repeated short trips B. Driving on rough roads C. Driving on dusty roads D. Towing a trailer If the vehicle is used under these conditions, change the fluid every 20,000 miles (32,000 km) 1. Place a large drain pan under the oil pan.
2. Remove the transmission oil drain screw (2) and drain fluid. 3. Tighten drain screw (2). Torque: 38 Nm (28 ft. lbs.) 4. Remove the transmission overfill screw (1) and fill transmission through overfill screw opening, using DEXRON-III ATF. Note: Add transmission fluid until it flows out over the overfill screw opening. 5. Let engine idle until a fluid temperature between 32°C (90°F) and 57°C (135°F) is reached. 6. Add transmission fluid until it flows out over the overfill screw opening, then close the overfill screw (1). Torque: 38 Nm (28 ft. lbs.) Note: To prevent fluid leaks, the overfill screw and oil drain screws gasket must be replaced each time these screws are removed. Note: Check transmission fluid temperature with scan tool. 7. Reset "Oil Life Monitor" data by using Tech 2.
Oil capacity .............................................. 8.6 liter (9.1 qt)
.....Please ACCEPT my answer by clicking the accept button, so I can get credit for my work.i don't receive commission unless you do ..I'm not always going to be giving you good news,so please don't let this stand in the way of you accepting my answer.it does not cost you more money.we will still be able to communicate.please understand,i can not see,hear or touch the vehicle and only know what you tell me. Bonuses and positive feedback are appreciated!if you are not satisfied with my answer,please do not leave bad feed back,i will gladly opt out and let another expert handle the question.if i have sent any diagrams,please print them.they will only stay on here for an hour or so...sometimes you may need to right click the image,then save picture as]to save it to your computer so you can open it with your picture program...PLEASE ASK IF YOU NEED MORE HELP