How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tom Your Own Question
Tom
Tom, ASE Certified Technician
Category: Car
Satisfied Customers: 25951
Experience:  ASE Certified Master Technician
3827149
Type Your Car Question Here...
Tom is online now
A new question is answered every 9 seconds

Voltage..New timing belt 2000 miles agoreplaced distributor..rebuilt

Customer Question

1995 Geo 1.8L Engine
will not start have no fire to spark plugs
with a test light checked to see if any voltage
to this distributor and I did have voltage. check to make sure
rotor was turning. New timing belt 2000 miles ago
replaced distributor with a rebuilt had same problem
Not sure but if you have juice going to the distributor
it would not be the computer?
Submitted: 5 years ago.
Category: Car
Expert:  Tom replied 5 years ago.
Has the ignition module been replaced?
Customer: replied 5 years ago.
NO
Expert:  Tom replied 5 years ago.
Ok this is the next step if timing and the distributor is ok need to start here next .
Customer: replied 5 years ago.
Timing OK and Distributor New
Expert:  Tom replied 5 years ago.
Ok need to check the ignition module next . Most likely the issue .
Customer: replied 5 years ago.
will try
Expert:  Tom replied 5 years ago.
Ok . That would be the next step. The ECM should be ok if the ignition module is not the issue it would be the ECM next. Hoped this helped. Positive feedback and bonuses greatly appreciated.
Customer: replied 5 years ago.
where is the ignition module located?
Expert:  Tom replied 5 years ago.
The module or "Igniter is located at the left rear under hood say right near the diagnostic connector, under the master cylinder, to left of fuel filter area. It controls the ignition.

ClickHere
Hoped this helped. Positive feedback and bonuses greatly appreciated.
Customer: replied 5 years ago.
change the module still not starting
Expert:  Tom replied 5 years ago.
Ok then it has to be the ecu . Get one from eBay or a salvage yard about 100 dollars no programming needed this is the next step. Hoped this helped. Positive feedback and bonuses greatly appreciated .