How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Certified Technician
Category: Car
Satisfied Customers: 12744
Experience:  32 years Foreign / Domestic Cars All aspects of Diag and Repair
13677702
Type Your Car Question Here...
Randall C is online now
A new question is answered every 9 seconds

How do you remove the center console on 2006 land rover hse 2006

Resolved Question:

how do you remove the center console on 2006 land rover hse 2006
Submitted: 5 years ago.
Category: Car
Expert:  Randall C replied 5 years ago.
Hello, I am Randall. there are different pages with steps but i have sent the finish panel info as well as consol info. I think this will be enough to assist you

Finisher - Console

Service Repair No - 76.25.07


Remove

  1. Remove gear selector cover.



  1. Release gaiter from handbrake lever grip.
  2. Release and remove handbrake lever grip.
  3. Open cubby box lids, carefully release clips and remove finisher.



  1. Remove 6 Torx screws securing finisher to center console, fully apply handbrake.
  2. Release finisher from clips, raise and disconnect 3 Lucar connectors from accessory power socket.
  3. Disconnect multiplug from closing panel lamp assembly.
  4. Remove center console finisher.

NOTE: Do not carry out further dismantling if component is removed for access only.

  1. Remove 2 Torx screws securing accessory socket and remove socket.
  2. Remove 4 Torx screws securing cubby box and remove box.
  3. Remove 3 Torx screws securing cup holder and remove cup holder.
  4. Remove handbrake lever gaiter

Center Console

Service Repair No - 76.25.01


Remove

  1. Remove center console finisher.
  2. Remove both center console closing panels.



  1. Remove 2 Torx screws securing large cubby box liner, remove liner.



  1. Remove 2 Torx screws securing ignition switch to center console.
  2. Remove 4 Torx screws securing center console to fascia.



  1. Remove 2 Torx screws and collect washers from base of large cubby box.



  1. Remove 2 screws securing center console rear closing panel. Release clips and remove panel.



  1. If fitted: Disconnect 2 multiplugs from AVIO module.
  2. Raise rear of center console, disconnect 3 multiplugs from center console and collect air duct adaptor.
  3. Disconnect 3 Lucar connectors from accessory power socket.
  4. Carefully remove center console.

Closing Panel - Center Console

Service Repair No - 76.25.31


Remove



  1. Remove screw securing closing panel to fascia.
  2. Release 2 clips securing closing panel and remove from lower fascia.

NOTE: Do not carry out further dismantling if component is removed for access only.

  1. Remove 6 screws securing trim finisher to closing panel. Remove finisher.
  2. Remove damper.
  3. Remove 2 trim clips.



Randall C and 7 other Car Specialists are ready to help you