How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Certified Technician
Category: Car
Satisfied Customers: 12744
Experience:  32 years Foreign / Domestic Cars All aspects of Diag and Repair
13677702
Type Your Car Question Here...
Randall C is online now
A new question is answered every 9 seconds

change the left rear brake bulb on a 2007 lr3..easiest way to do that

Resolved Question:

Hi: I need to change the left rear brake bulb on a 2007 LR3. Not sure if its the upper or lower one? Can you give me the easiest way to do that? My daughter had her DMV driving test and they failed my LR3 due to mechanical (break light out) :(. Please help!!! Thanks! Joe
Submitted: 5 years ago.
Category: Car
Expert:  Randall C replied 5 years ago.
Hello, you have to remove the screws in the edge after gate open. then kind of pull on slight angle to release the 2 clips still holding the light assy. All hulbs can be changed from there
ear Lamp Assembly

Removal
  1. Open the liftgate and tailgate.

CAUTION: Always protect paintwork and glass when removing exterior components.

  1. Remove the rear lamp assembly.
    • Remove the 2 screws.
    • Release the 2 clips.
    • Disconnect the electrical connector.



NOTE:

  • Do not disassemble further if the component is removed for access only.
  • Note the fitted position.
  1. Remove the wiring harness.
    • Release the wiring harness from the 2 clips.
    • Release the 6 bulb holders.
    • Release the electrical connector.



Installation

  1. Install the wiring harness.
    • Install the 6 bulb holders.
    • Install the electrical connector.
    • Secure the wiring harness in the clips.
  1. Install the rear lamp assembly.
    • Connect the electrical connector.
    • Secure with the 2 clips.
    • Tighten the screws.
  1. Close the tailgates.

 


Randall C and 13 other Car Specialists are ready to help you