How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Master Tech Matt Your Own Question
Master Tech Matt
Master Tech Matt, ASE and Chrysler Master Technician
Category: Car
Satisfied Customers: 1608
Experience:  20 years automotive experience, Factory trained by Chrysler, Jeep, Dodge, and Toyota
Type Your Car Question Here...
Master Tech Matt is online now
A new question is answered every 9 seconds

98 jeep cherokee: output speed senser circuit malfunction..replaces

This answer was rated:

98 jeep cherokee 4.0 engine ligth on code p0720 output speed senser circuit malfunction i replaces sensor clear code ligth came on again ?????
thank you
Where is the sensor you replaced located, and what does it look like?
Customer: replied 6 years ago.
tranfer case 3 wire plug round with a rod
That is not the output speed sensor. That is the vehicle speed sensor. The output speed sensor is a transmission sensor. It is located on the transmission case, on the drivers side towards the back. It will have a two wire connector on it, and it screws in to the transmission case, to remove it, you unscrew it, like removing a screw. You need to replace THIS sensor. You may lose some transmission fluid when you remove the sensor, so have a couple of quarts handy to top off the transmission.
Master Tech Matt and 9 other Car Specialists are ready to help you