How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Certified Technician
Category: Car
Satisfied Customers: 12787
Experience:  32 years Foreign / Domestic Cars All aspects of Diag and Repair
13677702
Type Your Car Question Here...
Randall C is online now
A new question is answered every 9 seconds

How do I remove the rear center console with cup holder from

This answer was rated:

How do I remove the rear center console with cup holder from a 2001 Lincoln Navigator? There is no wiring or air ducts involved. Just need to know how to get the console removed. Have found the 2 outside bolts on each side at rear of console wich loosend rear but still is attached to floor at front. Thanks

Hello, below are to directions for removal. you will have to pull some trim and there are some more screws

 

REMOVAL

  1. Position the front seat forward.

  1. Remove the two front floor console rear bolts.
  2. Position the front seats rearward.
  3. Disconnect the battery ground cable.

  1. If equipped, remove the console finish panel mat.

  1. If equipped, remove the console finish panel front screw.

  1. Remove the console finish panel rear screw.

  1. Remove the console finish panel.
    • If equipped, disconnect the parking aid switch electrical connector.
    • If equipped, disconnect the navigation display unit electrical connectors.
    • If equipped, disconnect the auxiliary A/C control electrical connectors.

  1. Remove the front floor console front bolts.

  1. Disconnect the front floor Console electrical connector.
    • If equipped, disconnect the any necessary electrical connector.

  1. Remove the floor console.
    • Lift the front of the floor console and slide rearward to disengage the floor brackets.

INSTALLATION

  1. To install, reverse the removal procedure.
Randall C and other Car Specialists are ready to help you
Customer: replied 7 years ago.
Mine is a rear console located between the two captains chairs in the second row seating. The console is a simple box with no electrical or air connections. I have located the 2 exterior side bolts at the rear of the console and now the rear of the console can be lifted a little. I am unable to locate screw or bolt to loosen the front of the console. Any advice on where the screw or bolts are located will help. Thanks
Sorry missed that it was rear. i assumed front. Let me check. back shortly

REMOVAL

  1. Tilt the rear seats forward.

  1. Remove the cupholder. NOTE: Pull upward on the center of the cupholder to release the pin-type retainers.

  1. Remove the rear floor console front screws.

  1. Remove the two rear floor console rear screws.

  1. Remove the rear floor console.

INSTALLATION

  1. To install, reverse the removal procedure.
Randall C and other Car Specialists are ready to help you