How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Doug Your Own Question
Doug, ASE Certified Technician
Category: Car
Satisfied Customers: 8535
Experience:  16 years automotive and OTR repair including specialized training from Toyota and Mitsubishi
Type Your Car Question Here...
Doug is online now
A new question is answered every 9 seconds

2003 eclipse: there a fuse that run the feature

Resolved Question:

I have a 2003 eclipse it only has one working key so i bought remote for it and trying to program it but its not working. Is there a fuse that run the feature that could be bad or removed
Submitted: 6 years ago.
Category: Car
Expert:  Doug replied 6 years ago.
The timing is very critical in this process.

Insert the key and turn the ignition to ON.
Within 5 seconds, insert the jumper wire between pins 1 and 4 on the DLC connector.
Within 5 seconds, push the Hazard switch 6 times.
The door locks will cycle, acknowledging program mode. If the locks do not cycle, your timing was off and you must start again, including taking the key out of the ignition.
Press a button on the new remote and hold it for one second then release. Within 2 seconds press the same button two more times.
The locks should cycle, ackowledging the code has registered.
Doug and 11 other Car Specialists are ready to help you

Related Car Questions