How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mike Kelly Your Own Question
Mike Kelly
Mike Kelly, Auto Mechanic
Category: Car
Satisfied Customers: 5469
Experience:  17 years experience as a auto mechanic,foreign and domestic.5 years running my own repair business.
19374685
Type Your Car Question Here...
Mike Kelly is online now
A new question is answered every 9 seconds

1995 LINCOLN TOWN CAR HEAT ONLY COMING FROM VENTS, A/C DOES

Resolved Question:

1995 LINCOLN TOWN CAR HEAT ONLY COMING FROM VENTS, A/C DOES WORK, CAN NOT SWITCH TO A/C FROM HEATER CONTROLS
Submitted: 7 years ago.
Category: Car
Expert:  Mike Kelly replied 7 years ago.
Hi,from what you are describing your blend door motor


REMOVAL & INSTALLATION

1990-98 Vehicles with Automatic Temperature Control

1.Disconnect the negative battery cable.
2.Remove the instrument panel; refer to .
3.Disconnect the electrical harness to the temperature controller on the control assembly, from the blend door actuator.
4.Remove the 4 screws and remove the blend door actuator from the plenum.


To install:

5.Position the blend door actuator on the plenum. Make sure the actuator cam is properly engaged with the temperature blend door crank arm.
6.Secure the blend door actuator to the plenum with the 4 screws.
7.Connect the temperature controller electrical harness to the blend door actuator.
8.Install the instrument panel and connect the negative battery cable.










Edited by XXXXX XXXXX on 11/2/2009 at 1:21 AM EST
Mike Kelly and 6 other Car Specialists are ready to help you

Related Car Questions