How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Eric Your Own Question
Eric, Automotive Repair Shop Manager
Category: Car
Satisfied Customers: 29707
Experience:  Automotive Repair Shop Manager, Technician/JA Mentor
Type Your Car Question Here...
Eric is online now
A new question is answered every 9 seconds

How To Replace A Blower Motor On 2007 Pontiac G6?

Customer Question

How do you replace the blower motor on a 2007 Pontiac G6 4 cylinder?

Submitted: 7 years ago.
Category: Car
Expert:  Eric replied 7 years ago.

The blower motor is located underneath the right side of the dash.

Below are specific directions:

Removal Procedure:

Remove the right closeout panel.

Remove the blower motor wire harness connector.


Important: Cut through the case as straight as possible because the motor cup must be reused. In order to prevent damage to the component, do not cut any deeper than necessary to remove the motor cup.

Cut out the blower motor using a utility knife in the narrow groove of the lower case.

Remove the blower motor.
Remove the blower motor nuts.
Remove the blower motor from the blower motor cup.

Installation Procedure

Install the new blower motor to the blower motor cup.
Notice: Refer to Fastener Notice in the Preface section.

Install the blower motor nuts.
Tighten the nuts to 2.4 N·m (21 lb in).

Install the motor blower seal to the blower motor ring.
Install the blower motor.
Install the blower motor attachment ring.
Install the blower motor screws.
Tighten the screws to 1.5 N·m (13 lb in).

Install the blower motor wire harness connector.
Install the right closeout panel.

Eric and 5 other Car Specialists are ready to help you
Customer: replied 7 years ago.

Do you know where I could find a blower motor seal/how I could reattach the cup once I have cut it open?

Expert:  Eric replied 7 years ago.

I have only found the blower motor seal and attachment ring at a dealer- haven’t found one aftermarket yet. The attachment ring mounts the blower motor mounted in the cup to the hvac housing by being screwed to the hvac housing where I have highlighted in yellow:


Before starting this, go to your local Pontiac dealer to get the seal and attachment ring first- last one I did, I had to wait a week for the parts kit to come in.

Related Car Questions