How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Certified Technician
Category: Car
Satisfied Customers: 12803
Experience:  32 years Foreign / Domestic Cars All aspects of Diag and Repair
13677702
Type Your Car Question Here...
Randall C is online now
A new question is answered every 9 seconds

2008 mazda 6: a diagram on how to remove the front bumper..headlights

This answer was rated:

Is there a diagram on how to remove the front bumper from 2008 mazda 6 to access the headlights?

Hello, here are instructions to remove front bumper. Thanks

 

 

FRONT BUMPER REMOVAL/INSTALLATION

  1. Disconnect the negative battery cable.
  2. Remove in the order indicated in the table.

  1. Disconnect the front side maker light connector.
  2. Disconnect the front fog light connector. (Vehicles with front fog lights)
  3. Install in the reverse order of removal.
  4. Adjust the front fog light aiming for vehicles with front fog lights.

Front Bumper Removal Note

  1. Pull the front bumper ends (wheel arch) outward to disengage from the bumper slider. CAUTION: If only one side of the front bumper is disengaged from the bumper slider and the bumper falls, it could be damaged. When disengaging the front bumper from the slider, secure the bumper so that it does not fall.
  2. Remove the front bumper from the body.

Front Bumper Installation Note

  1. Spread the front bumper ends (wheel arches) apart.
  2. Attach the front bumper to the body.
  3. Press the front bumper connecting area into the body to engage with the bumper slider.

 

Randall C and 8 other Car Specialists are ready to help you