How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jerry Your Own Question
Jerry
Jerry, Master Mechanic
Category: Car
Satisfied Customers: 17014
Experience:  ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager
2947720
Type Your Car Question Here...
Jerry is online now
A new question is answered every 9 seconds

How to perform a brake on the front of a infiniti fx35 2007

Resolved Question:

how to perform a brake on the front of a infiniti fx35 2007
Submitted: 7 years ago.
Category: Car
Expert:  Jerry replied 7 years ago.
Hello and welcome to Just answer.com, Super mechanic here. About your vehicle.

DId you plan to replace the rotors, or just the pads?
Customer: replied 7 years ago.
i would like to resurface the rotors or turn them, and replace the pads on the fronts only please
Expert:  Jerry replied 7 years ago.
Let me give you the instructions for that. When you take the pads out, you will then want to take out the bolts for the torque member and the rotor will pop off with the help of a few taps with a hammer.

I am having problems with uploading the pictures at this time.



Removal and Installation of Brake Pad


REMOVAL
  1. Remove tires from vehicle with power tool.
  2. Remove lower sliding pin bolt.

Hang cylinder body with a wire, and remove pads, pad retainers, shims from torque member.


  1. Apply PBC (Poly Butyl Cuprysil) or equivalent to the both sides of inner shim and outer shim, install inner shim to inner pad, and outer shim and outer shim cover to outer pad.
  2. Apply PBC (Poly Butyl Cuprysil) or equivalent to pad contact surface on pad retainer, and install pad retainers and pads to torque member. CAUTION: Inner pad and outer pad have pad-return mechanism on upper side of pad retainer. When installing pad to torque member, be sure to install pad return lever to pad wear sensor securely.
  3. Install cylinder body to torque member. CAUTION: When replacing pads with new ones, press in piston until pads can be installed. In this case, carefully monitor brake fluid level in reservoir tank because brake fluid will return to master cylinder reservoir tank.
  4. Install lower sliding pin bolt, and tighten it to the specified torque. Refer to BR-19, Components.
  5. Secure disc rotor with wheel nuts. Depress brake pedal a few times until it gets a responsive touch.
  6. Check brake for drag.
  7. Install tires to vehicle.


Jerry and other Car Specialists are ready to help you

Related Car Questions