How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mauricio Your Own Question
Mauricio
Mauricio, Technician
Category: Car
Satisfied Customers: 845
Experience:  15 years working in all makes and models
12133139
Type Your Car Question Here...
Mauricio is online now
A new question is answered every 9 seconds

How do you remove the radio in a 98 hyundai elantra

Customer Question

how do you remove the radio in a 98 hyundai elantra
Submitted: 8 years ago.
Category: Car
Expert:  Mauricio replied 8 years ago.
Expert:  Mauricio replied 8 years ago.
  1. Disconnect the battery negative terminal.

  1. Remove the shift lever boot and the rheostat assembly using a (-) driver.

  1. Remove the center facia panel mounting screws. (2EA)

  1. Disconnect the heater control cable and connectors (6EA), and then remove the center facia panel.

  1. Remove the audio mounting screws (4EA) and remove the audio.
  2. Installation is the reverse order of removal procedure.
Customer: replied 8 years ago.

how do you disconnect the heater control cable and connectors

 

Expert:  Mauricio replied 8 years ago.

COMPONENTS

REMOVAL


  1. Disconnect the temperature control cable end from the heater unit.

  1. Pull out the rheostat with a flat tip (-) screw driver.
  2. Disconnect the rheostat connector and remove the rheostat.

  1. Remove the shift lever upper cover.

  1. Remove the center facia panel mounting screws.

  1. Pull out the center facia panel.

  1. Disconnect switch extension wire connector, vacuum harness connector, blowers switch connector, A/C switch connector and cigarette lighter connector.
  2. Remove the center facia panel.

  1. Remove the heater control panel mounting screws.

  1. Remove the heater control panel assembly from the center facia panel.

INSTALLATION
Installation is the reverse order of removal.