How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask stin1974 Your Own Question
stin1974, Auto Service Technician
Category: Car
Satisfied Customers: 765
Experience:  Domestic transmission diagnostics and troubleshooting. General repair diagnostics and troubleshoot.
Type Your Car Question Here...
stin1974 is online now
A new question is answered every 9 seconds

How do you replace a head light bulb in a 2003 chevy trailblazer?

Resolved Question:

How do you replace a head light bulb in a 2003 chevy trailblazer?
Submitted: 7 years ago.
Category: Car
Expert:  stin1974 replied 7 years ago.



CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

  • Turn off the lamp switch and allow the bulb to cool before changing the bulb.
  • Leave the lamp switch OFF until the bulb change is complete.
  • Always wear eye protection when changing a halogen bulb.
  • Handle the bulb only by its base. Avoid touching the glass.
  • Keep dirt and moisture off the bulb.
  • Properly dispose of the used bulb.
  • Keep halogen bulbs out of the reach of children.

NOTE: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.

  1. Open the hood.
  2. Remove the headlamp.
  3. graphic
    1. Remove the access cover from the rear of the headlamp.
    2. Disconnect the electrical connector from the socket.
    3. Rotate the bulb and socket counter clockwise in order to remove the bulb and socket from the housing.
    4. Disconnect the electrical connector from the socket.
    5. Remove the bulb and socket from the headlamp.



    • Replace a high beam bulb with another high beam bulb. The high beam bulb has a black socket.
    • Replace a low beam bulb with another low beam bulb. The low beam bulb has a gray tip and a grey socket.
      1. Position the bulb and socket to the headlamp.
      2. Connect the electrical connector to the socket.
      3. Install the bulb and socket to the housing by rotating the bulb and socket clockwise, locking the retaining tabs to the housing.
      4. Install the access cover to the rear of the headlamp assembly
      5. Install the headlamp
      6. .
stin1974 and 8 other Car Specialists are ready to help you

Related Car Questions