How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mauricio Your Own Question
Mauricio
Mauricio, Technician
Category: Car
Satisfied Customers: 845
Experience:  15 years working in all makes and models
12133139
Type Your Car Question Here...
Mauricio is online now
A new question is answered every 9 seconds

I have a 2004 chrysler sebring and the oil pressure light started

Resolved Question:

I have a 2004 chrysler sebring and the oil pressure light started coming on at idle speed I have done some research and I found something about a tech bullitin #08-36-99 i thought it might have been a sending unit and replaced it but it didn't help
Submitted: 8 years ago.
Category: Car
Expert:  Mauricio replied 8 years ago.
Did you perform the repair by the bulletin info?
Customer: replied 8 years ago.
I can't find the bullitin to make repair there is 80000 miles on this engine and it just started coming on and i have changed the oil every 3000 miles since I have had the car about 21/2 years
Expert:  Mauricio replied 8 years ago.

NUMBER: 08-36-99

GROUP: Electrical

DATE: Oct. 15, 1999

SUBJECT:
Engine Oil Pressure Light Flicker

 

OVERVIEW:
This bulletin involves adding a terminal/wire/vent to the oil pressure switch connector.

 

M

 

NOTE :THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 2.7L ENGINE.

 

SYMPTOM/CONDITION:
With a hot engine the oil pressure light may be on or flicker on at idle.

 

DIAGNOSIS:
Verify engine oil pressure as described on page 9-21 of the 1999 Concorde/Intrepid/LHS/300M service manual (Publication No. 81-270-9140). If engine oil pressure is within specification perform the Repair Procedure.

 

PARTS REQUIRED:

1 05017800AA Wire Terminal/Vent

 

REPAIR PROCEDURE:

1.Raise vehicle on a suitable hoist.

 

2.Remove engine oil pressure switch connector from switch.

 

3.Remove sealing dart from the empty cavity at the rear of the connector.

 

4.Pull terminal locking ring outward from front (switch) side of connector to gain access to terminal locking tabs.

 

5.Install wire terminal/vent, p/n 05017800AA, in place of the removed sealing dart. Slide locking ring back into place.

 

6.Attach the connector back on the oil pressure switch.

 

7.Spot tape the wire/vent to follow the harness towards the top of the engine compartment.

 

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No: 08-90-65-96 0.2 Hrs. FAILURE CODE: P8 - New Part
Mauricio and 8 other Car Specialists are ready to help you
Customer: replied 8 years ago.
Do you have any idea why this would show itself after 80000 miles