How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask OnlineHelp Your Own Question
OnlineHelp
OnlineHelp, Mechanic
Category: Car
Satisfied Customers: 3423
Experience:  Mechanic
9051600
Type Your Car Question Here...
OnlineHelp is online now
A new question is answered every 9 seconds

i NEED A DIAGRAM TO REPLACE WATER PUMP ON A 1999 GRAND AM 3.

Customer Question

i NEED A DIAGRAM TO REPLACE WATER PUMP ON A 1999 GRAND AM 3.4
Submitted: 8 years ago.
Category: Car
Expert:  OnlineHelp replied 8 years ago.
Hello and thannk you for choosing Just Answer.
3.4L Engine (Remove Drive Belt 1st)

 

  1. Remove the engine mount.

  2. Use a 3/8 inch breaker bar in order to rotate the drive belt tensioner in a counterclockwise motion.

    To remove the belt, use a 3/8 inch breaker bar in order to rotate the drive belt tensioner in a counterclockwise motion

    To remove the belt, use a 3/8 inch breaker bar in order to rotate the drive belt tensioner in a counterclockwise motion

  3. Remove the drive belt.

To install:

  1. Use a 3/8 inch breaker bar in order rotate the drive belt tensioner in a counterclockwise motion.

  2. Install the drive belt. Connect the drive belt last to the power steering pulley.

  3. Install the engine mount.



3.4L Engines

  1. Before servicing the vehicle, refer to the precautions section.

  2. Disconnect the negative battery cable.

  3. Drain the cooling system.

  4. Remove or disconnect the following:

    • Drive belt

    • Water pump pulley

    • Water pump

To install:

Exploded view of the water pump mounting—3.1L & 3.4L engines

Exploded view of the water pump mounting—3.4L engines

Click to Enlarge

  1. Install or connect the following:

    • Water pump with a new gasket. Torque the bolts to 89 inch lbs. (10 Nm).

    • Water pump pulley. Torque the bolts to 18 ft. lbs. (25 Nm).

    • Accessory drive belt

    • Negative battery cable

  2. Refill and bleed the cooling system.

  3. Test run the engine and check for leaks.

Customer: replied 8 years ago.
will i be able to print this with diagrams and info if I accept
Expert:  OnlineHelp replied 8 years ago.
Yes you can print it.