How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask John Your Own Question

John
John, Master Automotive Technician
Category: Car
Satisfied Customers: 9176
Experience:  ASE A1-A8 & L1 Master GM Tech 40 years experience
Type Your Car Question Here...
John is online now
A new question is answered every 9 seconds

My tag light is out on my 2003 Buick LeSabre. How do ...

Resolved Question:

My tag light is out on my 2003 Buick LeSabre. How do I get to the light and which fuse should I check too?
Submitted: 6 years ago.
Category: Car
Expert:  John replied 6 years ago.

HelloCustomer

Rear fuse block, under the rear seat, check fuses 10,13,&14.Replacing the bulbs is :

License Lamp Bulb Replacement


    Object Number: 506449  Size: SH

  1. Disconnect the tail/back up lamp harness connector from the from the body wiring harness.
  2. Remove the tail/back up lamp assembly from the rear compartment lid.
  3. While supporting the tail/back up lamp assembly, unplug the tail/back up lamp harness grommet from the rear compartment lid and remove the tail/back up lamp from the vehicle.
  4. Remove the license plate lamp bulb from the lamp housing.


    Object Number: 506449  Size: SH

  1. Install the license plate bulb into the lamp housing.
  2. While supporting the tail/back up lamp assembly, install the tail/back up lamp harness grommet to the rear compartment lid and install the tail/back up lamp.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the tail/back up lamp fasteners to the tail/back up lamp studs.

    Tighten
    Tighten the tail/back up lamp fasteners to 6 N·m (53 lb in).

  4. Connect the tail/back up lamp electrical connector.
  5. Connect the tail/back up lamp harness connector and clip the connector to the metal edge of the rear compartment lid.
John, Master Automotive Technician
Category: Car
Satisfied Customers: 9176
Experience: ASE A1-A8 & L1 Master GM Tech 40 years experience
John and 21 other Car Specialists are ready to help you

JustAnswer in the News:

 
 
 
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
 
 
 

What Customers are Saying:

 
 
 
  • I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry. Stephanie P Elm City, NC
< Last | Next >
  • I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry. Stephanie P Elm City, NC
  • used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future. David L. Richmond, TX
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil Marysville, CA
  • Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible. Charles Walnut Creek, CA
  • As a single woman, I really appreciate an excellent and affordable opinion.
    Thank you Geordie, I will not hesitate to contact justanswer in the future!
    Sue Charleston, WV
  • Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff. Jim Castleberry, FL
  • Excellent reply, and also very quick. Really sounds like the Expert knows what he is talking about. I will be back to use your service when I need more help with my RV. Dutch USA
 
 
 

Meet The Experts:

 
 
 
  • Chris (aka-Moose)

    Technician

    Satisfied Customers:

    846
    16 years of experience
< Last | Next >
  • http://ww2.justanswer.com/uploads/MU/muddyford/2012-6-13_1204_1.64x64.png Chris (aka-Moose)'s Avatar

    Chris (aka-Moose)

    Technician

    Satisfied Customers:

    846
    16 years of experience
  • http://ww2.justanswer.com/uploads/TE/TedG/2012-6-15_14759_avaLarge.64x64.jpg Ted G.'s Avatar

    Ted G.

    ASE Certified Technician

    Satisfied Customers:

    1596
    20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness
  • http://ww2.justanswer.com/uploads/joecamel90/2008-11-13_03615_head_shot.jpg George H.'s Avatar

    George H.

    ASE Certified Technician

    Satisfied Customers:

    1311
    ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist
  • http://ww2.justanswer.com/uploads/AM/amedee/2013-10-24_23656_Amedee1.64x64.jpg Amedee's Avatar

    Amedee

    ASE Master Tech

    Satisfied Customers:

    2367
    ASE Master Tech advanced level specialist
  • http://ww2.justanswer.com/uploads/SU/supermechanic/2013-8-23_03546_500.64x64.jpg Jerry's Avatar

    Jerry

    Master Mechanic

    Satisfied Customers:

    1906
    ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager
  • http://ww2.justanswer.com/uploads/CR/crzydrvr00/2013-11-3_12123_246347.64x64.jpg Richard's Avatar

    Richard

    ASE Certified Technician

    Satisfied Customers:

    942
    12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes
  • http://ww2.justanswer.com/uploads/ST/Steve7654/2012-6-5_215929_japic800x660.64x64.jpg Steve's Avatar

    Steve

    Auto Service Technician

    Satisfied Customers:

    1980
    25+ yrs experience as a professional working technician; ASE L1 master technician