How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask GM-Frank Your Own Question
GM-Frank
GM-Frank, ASE Master Certified
Category: Car
Satisfied Customers: 431
Experience:  37 Years Automotive Diagnosis & Repair. Experience with all makes and models..
10184299
Type Your Car Question Here...
GM-Frank is online now
A new question is answered every 9 seconds

A drawing of how the serpentine belt is routed around the pulleys

This answer was rated:

Do ypu have a drawing of how the serpentine belt is routed around the pulleys?

 

HelloCustomer

I believe this is what you are looking for.

graphic

  1. Disconnect negative battery cable. NOTICE: Engine must be supported upon removal of engine mount.
  2. Remove right front engine mount and engine mount bracket from engine block.
  3. Use a 15 mm wrench to rotate the tensioner pulley clockwise while sliding the drive belt off the tensioner or water pump pulley. Remove drive belt.

  4. Clean and inspect the serpentine drive belt surfaces.

 

graphic

  1. Route belt around all pulleys, except tensioner or water pump. IMPORTANT: Ensure that drive belt is aligned into the proper grooves on the drive pulley.
  2. Use a 15 mm wrench to rotate the tensioner pulley clockwise.
  3. Slip the belt over the idler or water pump pulley.
  4. Install right front engine mount. Refer to "Engine Mount Installation".
  5. Reconnect negative battery cable.

This should get you through it.

Take Care

Frank

GM-Frank and 7 other Car Specialists are ready to help you