How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Shawn Your Own Question
Shawn
Shawn, ASE Certified Technician
Category: Car
Satisfied Customers: 655
Experience:  PA Certified Inspection emissions, ASE Brakes Suspension, Lead diagnostic Tech.20 years exp
9265294
Type Your Car Question Here...
Shawn is online now
A new question is answered every 9 seconds

1998 Mazda 626: you program a new cut transponder key..keys

This answer was rated:

How do you program a new cut transponder key for a 1998 Mazda 626 using two existing working transponder keys?
Customer

Here are the procedures for programming the key. You'll most likely need to use the first one since you already have 2 programmed keys.


IMMOBILIZER SYSTEM -1998 Mazda 626 LX Page 1 of 1

 


KEY REPLACEMENT OR ADDITION


Customer Supplied 2 Or More Valid Keys

1.Cut new transponder equipped key(s). Using 1st key, turn
ignition to ON position, then LOCK position 5 times. Turn 1st
key to ON position. SECURITY light should illuminate. Turn 1st
key to LOCK position. SECURITY light should go out.
2.Using 2nd key, start engine. SECURITY light should illuminate
for 1-2 seconds and engine should continue to run. Turn 2nd key
to LOCK position and remove key.
3.Repeat step 2) with 1st key. Repeat step 2) with new key. Repeat
step 2) with each new or valid key, up to 8 keys total. Wait 30
seconds, program will quit automatically.


Customer Supplied Only One Or No Valid Keys

1.Cut new transponder equipped key(s). Using new key, turn
ignition to ON position, then LOCK position 5 times. Turn new
key to ON position. SECURITY light should be flashing at 300
millisecond interval. Turn new key to LOCK position and wait
about 5 minutes until SECURITY light flashing has decreased to
1.2 second interval.
2.Input code word. See INPUTTING CODE WORD. SECURITY light should
stop flashing and stay illuminated. Start engine with new key.
SECURITY light should illuminate for 1-2 seconds and engine
should continue to run. Turn new key to LOCK position and remove
key.
3.Using new 2nd key, start engine. SECURITY light should
illuminate for 1-2 seconds and engine should continue to run.
Turn new 2nd key to LOCK position and remove key.
4.Repeat step 3) with valid key or new 3rd key. Repeat step 3)
with each new key, up to 8 keys total. Wait 30 seconds, program
will quit automatically.


 

 

 

 

Shawn

Shawn and 6 other Car Specialists are ready to help you