Have a Car Question? Ask a Mechanic Online.
Hi, welcome to Justanswer.com
THESE INSTRUCTIONS ARE TO REMOVE THE PUMP BUT AT THE END IT TELLS YOU TO INSTALL OIL TO PUMP RESEVOIR
HYDRAULIC PUMP ASSEMBLY
Review the complete service procedure before starting this repair. The convertible top on this model will raise slowly or make abnormal noise if the hydraulic fluid level is low.
Disconnect the negative battery cable.
Remove the sling well and floor cover from behind the rear seat.
Disconnect pump wire connector and ground connection.
Disconnect hydraulic lines from the pump assembly.
Remove the motor pump assembly from the vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up motor assembly to remove.
Position the motor assembly in the vehicle.
Install the hydraulic lines to the pump assembly.
Attach the pump wire connector and ground connection.
Install the sling well and floor cover behind the rear seat.
Connect the negative battery cable.
Fill the pump reservoir with Dexron® II, type A, automatic transmission fluid to the bottom of the fill hole.
hope this helps.______________PLEASE CLICK ON "ACCEPT" IF I WAS HELPFUL-OR IF YOU NEED FURTHER ASSISTANCE JUST ASK, THANKS