How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask "Super Dave" Forrest Your O...
"Super Dave" Forrest
"Super Dave" Forrest, ASE Certified Technician
Category: Car
Satisfied Customers: 39
Experience:  ASE Certified Master Technician, ASE Advanced Engine Performance, Over 15 years experience.
Type Your Car Question Here...
"Super Dave" Forrest is online now
A new question is answered every 9 seconds

99 jeep cherokee laredo: replaced rear disc pads..4x4

This answer was rated:

What tools are needed to replaced rear disc pads on a 99 jeep cherokee laredo 4x4

A flat blade screwdriver.

Metric allen wrenches (I'm not positive, but I think you'll need a 7 or 8mm)

Remove your master cylinder cap.

Jack the vehicle and take the wheel off.

Using the flat screwdriver, insert into the opening of the top of the caliper and pry the caliper over to bottom out the piston.


Then use the screwdriver to remove the wire clip.


Now remove the slider pins with the allen wrench.



Hope this helps, good luck!

(I thought I'd add that most vehicle manufacturers do not recommend using a screwdriver in this fashion to bottom the caliper piston, but this is in fact the prescribed method from Jeep)

"Super Dave" Forrest and 8 other Car Specialists are ready to help you

Related Car Questions