How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask ElectronicsPete Your Own Question
ElectronicsPete
ElectronicsPete, Electronic Engineer
Category: Car Electronics
Satisfied Customers: 16303
Experience:  Over 16 years of experience installing and repairing electronics.
30970729
Type Your Car Electronics Question Here...
ElectronicsPete is online now
A new question is answered every 9 seconds

I have a Viper 5706V with idatalink ADS-AL(DL)GM1 bypass.

Customer Question

I have a Viper 5706V with idatalink ADS-AL(DL)GM1 bypass. Type 1 install for a 2001 Monte Carlo. Everything turns on but it does not crank over. No power at the Green or Violet Starter wires when I try to remote start it. Starts with key only. Have Green connected to Key side of Yellow starter wire and Violet connected to the car side of the yellow wire. Ignition wire shows 12V
Submitted: 11 months ago.
Category: Car Electronics
Customer: replied 11 months ago.
even if the key is in the ignition when I try to remote start it, it wont crank over
Customer: replied 11 months ago.
I have a relay set up for the second Brown Accessary wire. Pin 30(Brown second accessory wire at ignition harness) Pin 85(Orange accessory negative output #23 from remote) Pin 86(Orange accessary positive output wire #8 from remote) Pin 87(red wire coming from ignition harness). Brown accessary wire shows 12V when remote start is activated.
Expert:  ElectronicsPete replied 11 months ago.

Hi there,

If no power is getting to the starter then first check if the remote starter is set correctly automatic or manual transmission.

Customer: replied 11 months ago.
It is set for Automatic

Related Car Electronics Questions