Recent Feedback
KENWOOD-CD-RECEIVER (KDC-MP5032 ) TRUCK BATTERY WENT DEAD -FACK PLACE REMOVED / GOT NEW BATTERY /PUT FACEPLATE BACK ON -ASKED FOR ACTIVATION CODE /WHEN I HAD RADIO INSTALLED NEVER ACTIVATED 4 DIGIT CODE /WHEN I REMOVED FACEPLATE I DID NOT ACTIVATE /HOW CAN I GET A CODE /SO I CAN USE MY RADIO------S/NO.60100930 /BAR CODE-019048 165121 /
Optional Information: Make: KENWOOD-CD-RECEIVER Model: KDC-MP5032 Already Tried: AS SOON AS RADIO POWER IS TURNED ON-IT ASK FOR ACTIVATION CODE /WITH-OUT CODE ,IT JUST SHUTS DOWN ---THINK I STOLE IT /BATTERY WENT DEAD -DID NOT REPLACE BATTERY FOR OVER 6 MONTHS / SO I STORED FACEPLACE INSIDE--NEW BATTERY -FACEPLATE ON-POWER-ON /SCREEN FOR ACTIVATION CODE -DID NOT GET A CODE UPON BUYING UNIT /DID NOT ACTIVATE A CODE MYSELF?
KENWOOD KDC SECURITY CODE CLEAR procedure Your code number is XXXX (KCAR) * Press numeric key "5" ( 2 times ) and press the Track UP/Next Track key * Press numeric key "2" ( 3 times ) and press the Track UP/Next Track key * Press numeric key "2" ( 1 time ) and press the Track UP/Next Track key * Press numeric key "7" ( 2 times ) and press the Track UP/Next Track key Your radio will require one of the following procedures. Type 1 During the code request mode, while holding the DISP key depressed, press and hold the Volume UP or DOWN key for 3 seconds (so that "..." disappears). Then using your remote enter your code. Type 2 Press the "Auto" button and "Track up" on face of radio at the same time. The four dash lines ( . . . . ) should "disappear". Then using your remote enter your code. Type 3 Model# XXX-XXXX and DPX-4030 Press and hold the 1 then the 6 preset key (preset keys are the buttons on face of radio for storing you "favorite" radio stationshttp://us.mc560.mail.yahoo.com/l
). "C" should display. Then using your remote, enter your code. Enter your number from the remote control unit. Your code number is XXXX (KCAR) * Press numeric key "5" ( 2 times ) and press the Track UP/Next Track key * Press numeric key "2" ( 3 times ) and press the Track UP/Next Track key * Press numeric key "2" ( 1 time ) and press the Track UP/Next Track key * Press numeric key "7" ( 2 times ) and press the Track UP/Next Track key The security is canceled and the set enters the TUNER mode! Also on completion of the code reset procedure , hold the track up button down for 3 seconds. If this does not work, then you'll need to contact Kenwood and have them factory unlock the unit by sending it to them.
If this answers your question, please click "Accept", as it is the only way we Experts get paid for our knowledge on the site. Tips and Bonuses are welcome and appreciated!!