I am installing a Prestige APS-620N remote start system on my 1997 Dodge Ram 1500 2WD 5.9 Gas automatic truck. The directions say to attach the green w/orange trace wire to the negative side of the coil. Wiring diagrams show this to be a black/gray wire at the coil connector. There are only two wires at the coil. I double checked this connection but the remote start does not receive a tach signal. Also, the truck has power door locks but no keyless entry, and I would like to know if I need something extra to have the remote operate the door locks, also. Thank you
Model: Ram 1500 2WD
Verified the connections for the remote start wiring diagram several times.
If you are needing for TACH:
I show it as GRAY / Light BLUE wire at the PCM
Powertrain Control Module Located On Passenger Rear Of Engine On Firewall
If your R/S does not have "onboard" Relays for Lock & Unlock, you will need 2 SPDT Relays (single pole double throw)
Lock = ORANGE/VIOLET wireUnlock = PINK/VIOLET wireAt Black 8 PIN CONNECTOR IN DRIVER KICK PANEL
You will need to determine which coonectios to make to Relays:
Without OEM Keyless = Reversal Rest At Ground Door Locks . With OEM Keyless Entry = Positive Pulse Door Locks .
if you need further, let me know
over 30 years, ARA, Sony, Alpine, Audiovox, Kenwood, Muntz. Sales, Repair & Installation
Can I accept your answer and pay you tomorrow after I try to find this wire on the PCM ? Thanks , Bill
not a problem
let me know if you need further