How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask camerontech Your Own Question
camerontech
camerontech, diagnostic auto tech
Category: Cadillac
Satisfied Customers: 427
Experience:  diagnostic auto tech
89602740
Type Your Cadillac Question Here...
camerontech is online now
A new question is answered every 9 seconds

I need to replace a left turn signal bulb on a Cadallic 2010

Customer Question

I need to replace a left turn signal bulb on a Cadallic 2010 dts
Submitted: 1 year ago.
Category: Cadillac
Expert:  camerontech replied 1 year ago.

HI there,

Im Cam, a licenced diagnostic tech.

The front bumper must be removed to be able to remove the headlight assembly to access the turn signal bulb.

It is not as bad as it sounds or looks. I have done lots and you should be able to do it in a couple hours. IF you have a hoist, it can help cut alot of time of the job.

IF you would like to attempt this, id be happy to show you the bolt location diagrams

cam

Customer: replied 1 year ago.
please
Customer: replied 1 year ago.
I need all the help I can get
Customer: replied 1 year ago.
Okay I am weighting
Expert:  camerontech replied 1 year ago.

ok, no problem,

it seems like it would be a nightmare job, but I can do them in about 20 mins now, I think my firts one took me an hour. So i dont think you will have an issue, just alot of screws, so your wrist will hurt, lol

Give me a few minutes and ill upload the diagrams.

I do ask for and appreciate a positve rating as i do pay for my diagrams and most experts charge extra for this, but i dont.

I just appreciate the rating before hand

thanks

give me a few mins as i have to prepare them for you

cam

Expert:  camerontech replied 1 year ago.

this is the bumper assembly,

the light assembly will follow

Expert:  camerontech replied 1 year ago.

here is the light assembly

Expert:  camerontech replied 1 year ago.

when you have the bumper off, it opens everything up. the headlight assembly itself will pop out of its retainers once all of the retaining screws are removed, this will require a bit of modest force as the retainer clip holds it tight.

you will be suprised how little the bumper is help on

thanks in advance for a positive rating and good luck with your repair!

cam

Expert:  camerontech replied 1 year ago.

hi there,

please dont forget to rate me as these diagrams do cost me money

thanks

cam

Expert:  camerontech replied 1 year ago.

c

Customer: replied 1 year ago.
What would cause the turn signal to still blink to fast even after changing the bulb?
Expert:  camerontech replied 1 year ago.

a few things could cause this.

1. a blown fuse - both fuse blocks must be check and and sure no fuses are blown

2. another blown bulb

3. wiring, most likley a ground

4. signal switch or bcm issue

Expert:  camerontech replied 1 year ago.

hi again,

I would appreciate a rating for my diagrams and information that i have provided for you.

this is an important part of my compensation

thanks

cam

Expert:  camerontech replied 1 year ago.

c